行業動態

不論是修補過后的鹽水機組，仍是新安裝的，或許壓縮機進行空氣負荷試運轉合格后的，咱們都要對該鹽水機組的全部體系進行吹除排污，以清除機組制冷體系內部的焊渣、砂子和鐵屑等雜物。
Whether after the repair of saline water machine, is a new installation, or air compressor load test run after passing, we are all on the system unit for blowing saline sewage, to clear the internal cooling system of welding slag, sand and debris.
咱們常用的風冷鹽水機組、水冷鹽水機組或螺桿式鹽水機組等，盡管機組有所不同，但是操作方法大致相像，詳細的要求和步驟如下：
We commonly used air - cooled brine unit, water - cooled brine unit or screw brine unit, and so on, although the unit is different, but the operation method is roughly similar, the detailed requirements and steps are as follows:
1、選用壓力為0.6Mpa（表壓）的清潔壓縮空氣或氮?dú)膺M(jìn)行吹掃，次數不少于3次。在吹掃過程中，還要用白紙?jiān)谂盼劭谠囼?yàn)，直到排出氣體不帶水汽、油污、鐵銹等雜物停止。
1, the pressure of 0.6Mpa (g) clean compressed air or nitrogen purge, not less than 3 times. In the blowing process, but also with a white paper in the outfall test, until the exhaust gas without water, oil, rust and other debris to stop.
假如有發現管路或閥門有顯著的漏氣點，要及時進行補焊，并將閥門的法蘭緊好。
If you have found that the pipeline or the valve has a significant leak point, to be timely repair welding, and the flange of the valve is good.
2、在給鹽水機組的體系排污后，記住將體系中所有的閥（除安全閥外）拆開清潔，保持潔凈度。假如有閥門的閥芯或密封線有損壞，要及時進行修補或更換。
2, after the system of water to the brine unit, remember to all the valve (in addition to the safety valve) apart clean, clean degree. If there is a valve spool or sealing line is damaged, to be repaired or replaced in a timely manner.
除了給鹽水機組的全部體系進行排污作業外，還要做氣密性試驗，真空試驗，以及充制冷劑試漏等試運轉程序。
In addition to the whole system of water to the brine unit for sewage operations, but also to do the air tightness test, vacuum test, as well as test run procedures such as filling refrigerant test.